DW 系列带式干燥机 DW series belt dryer
该机是穿流连续式干燥设备 ，用于透气性较好的片状、条状、颗粒状物料的干燥，对于脱水蔬菜、中药饮片等类含水率高、而温度不允许高的物料尤为合适；该系列干燥机具有干燥速度快、蒸发强度高、产品质量好的优点，对脱水滤饼状的膏状物料，需经造粒或制成棒状后亦可干燥。 This machine is a continuous flow drying device for drying sheet, strip, and granular materials with good air permeability. It is especially suitable for materials with high moisture content such as dehydrated vegetables, Chinese medicine decoction pieces and high temperature. ; This series of dryers have the advantages of fast drying speed, high evaporation strength and good product quality. The dehydrated cake-like paste-like materials can be dried after being granulated or made into rods.
The company has cooperated with Beijing Enfei, Nanchang Ruilin and other design institutes to develop copper-based anode mud non-standard belt dryers, which have been used by Jinchuan Company, Baiyin Company and other units with good results.
12-60 目不锈钢丝网，由传动装置拖动在干燥机内移动。 The material is evenly spread on the mesh belt by the feeder. The mesh belt generally adopts 12-60 mesh stainless steel wire mesh and is dragged by the transmission device to move in the dryer. The dryer is composed of several units. Each unit circulates hot air independently. Part of the exhaust gas is discharged by a special dehumidification fan. The exhaust gas is controlled by a regulating valve. The hot air passes from the bottom to the top or from the top to the bottom through the mesh belt covered with materials. The process of mass transfer takes away material moisture. The mesh belt moves slowly, and the running speed can be freely adjusted according to the temperature of the material. The dried product continuously falls into the receiver. The upper and lower circulation units can be flexibly equipped according to user needs, and the number of units can also be selected according to needs.
脱水蔬菜、颗粒饲料、味精、椰蓉、有机颜料、合成橡胶、丙稀纤维、药品、药材、小木制品、塑料制品、电子无器件老化、固化等。 Dehydrated vegetables, pellet feed, monosodium glutamate, coconut, organic pigments, synthetic rubber, acrylic fibers, medicines, medicinal materials, small wooden products, plastic products, electronic component aging, curing, etc.